**PLEASE ASK ANY QUESTIONS BEFORE ORDERING AS ALL SALES ARE FINAL, NO EXCEPTIONS**
This is a really good informative video about the care of your mount https://youtu.be/lmLSSq4XD7Y?si=GcPSLW4tGSI3gHUX
When choosing this mount you will have 2 options, Mount only which will come with the 2 set screws. And you also have the choice of that same mount with a fixed length matched stick. ALL mounts come with the center stainless screw to lock your selfi stick in. The mount comes standard with the center 1/4x20 stainless bolt that the selfi stick screws into as well as the 2 thumbscrews on the sides which really work best with the matched stick but will also aid in stability with your own stick! The fixed sticks are available in a 6" or 9" and the sticks are BLACK in color. (they are FIXED and not extendable)
MANY HOURS OF WATER TESTING IN VARIOUS CONDITIONS and I have made sure these are as strong as possible for their purpose, HOWEVER, these are 3D printed mounts, they are being put on fast skis, in unpredictable conditions and riding styles, people get thrown off skis, lose their balance boarding and grab the sticks or poles etc, it is for these reasons there can be NO WARRANTY on these mounts.
DO NOT OVER TIGHTEN THE SET SCREWS
use around salt water you should rinse often and spray wd40 on the threads to avoid corrosion between stainless steel and brass!
Color shades may differ from order to order as different material and batches maybe lighter, brighter, darker etc from other orders
Breakage due to misuse including excessive speed, wave jumping, using an extended pole or accidental grabbing or pulling on selfi stick etc is NOT replaceable under any circumstances.
This NEW DESIGN has some significant structural enhancements that should effectively eliminate a huge amount of the shaking and flexing the other mount had. It also has a deeper well where the selfie stick screws into the base which should improve the selfie stick rigidity.
**IMPORTANT*** This mount will work with this stick or similar in diameter. (https://amzn.to/3M25nfr) DO NOT EXTEND THE STICK WHILE RIDING!!!
It will accommodate a stick outside diameter of 25mm or approximately 1"
IT IS ALSO RECOMMENDED THAT YOUR SELFIE STICK BE USED IN THE FULLY COLLAPSED POSITION WHILE RIDING!
EXTREMELY ROUGH CONDITIONS SHOULD BE AVOIDED WHILE ATTACHING YOUR CAMERA TO THE MOUNT. Activities such as Wave jumping, etc are not recommended as this will greatly increase the chance of breaking your camera or mount.
I have been in some fairly rough seas under normal operation and have yet to break any mount.
For proper installation please watch this video. https://youtu.be/VA_S_dJ87jM?si=o98kA8nDeF2k9rwF
NRG assumes no liability for damaged cameras or damage to your ski due to normal or non normal use and installation of this mount. YOU ASSUME FULL RESPONSIBILITY!
THIS IS FOR 1 Mount. You must use your factory hood screws in your ski!
CAMERA AND SELFIE STICK NOT INCLUDED!
A use of a 1ft section of pool noodle is recommended to see how your mount/stick/camera selection works with your riding style, ski etc. we are not responsible for damage or loss of your camera/stick/ski. You accept all risks of using this mount!
**ONCE THE ORDER HAS SHIPPED IT CAN NOT BE RETURNED FOR ANY REASON...NO EXCEPTIONS. PLEASE ASK ALL QUESTIONS BEFORE ORDERING AS ALL SALES ARE FINAL**
seadoolife
seadoo
gopro
insta360
