NEW REVISION!!! NO MORE THUMB SCREW. TWIST REDUCER STYLE! SUPER EASY!
Bringing the game changer seadoo ski technology over to the Seadoo Switch. This mount Permanently mounts to the rear side of your seadoo switch as seen in the video here: https://youtu.be/aywsos8r1CQ
I recommend a flag of 2X4 for best results. HEAVY POLES can cause issues as well as CUSTOM double sided thick flags.
FULL INSTALLATION VIDEO HERE: https://youtu.be/v99iRuc6uI0
Ask any questions before ordering as all sales are final!!!
MANY HOURS OF WATER TESTING IN VARIOUS CONDITIONS and I have made sure these are as strong as possible for their purpose, HOWEVER, these are 3D printed mounts, they are being put on fast skis, in unpredictable conditions and riding styles, people get thrown off skis, lose their balance boarding and grab the sticks or poles etc, it is for these reasons there can be NO WARRANTY on these mounts.
****IMPORTANT***
although these are printed with UV and heat resistant materials, it is NOT recommended to leave these in direct heat even under a cover while exposed to direct sunlight when not in use. Some areas like here in Florida etc the temps even under a ski cover can be extreme and cause warping. So if your ski is not covered by a carport/garage etc. please remove your mount for safe storage!
**Color shades may differ from order to order as different material and batches maybe lighter, brighter, darker etc from other orders**
A use of a 1ft section of pool noodle is recommended to see how your mount/stick/camera selection works with your riding style, ski etc. we are not responsible for damage or loss of your camera/stick/ski. You accept all risks of using this mount!
Comes with everything you need (selfi stick, cameras or flags NOT INCLUDED!!!)
This is for (1) side game changer mount for the seadoo switch. Comes as shown with the mount, 2 stainless mounting bolts and stainless selfi mount in base. Also comes with a reducer cap to run a 1" flag pole or a smaller selfi stick if you dont have the 36mm stick.
Available in different colors. The reducer will be the same color as the mount.
As shown in the above video you will need a t30 bit and a 10mm socket to remove the existing nut and bolts from your switch, Then you will need to keep the nuts and reuse them on the new bolts and that bolt will need a 4mm hex head (allen key)
**ONCE THE ORDER HAS SHIPPED IT CAN NOT BE RETURNED FOR ANY REASON...NO EXCEPTIONS. PLEASE ASK ALL QUESTIONS BEFORE ORDERING AS ALL SALES ARE FINAL**
