LINQ mounted BEEFY Flag mount for SEADOO skis. NO TOOL NEEDED!

This flag mount designed for any 2018 or newer Seadoo ski with the built in linq retractable supports. Gtx, gti, rxt, rxpx etc.  It QUICKLY attaches and detaches and can carry up to a 1" flag pole with a 2'X4' flag. Keep in mind this is designed to display your flag while cruising etc, not designed for surf/wake jumping, excessive speed or any erratic operation. With the addition of the ability to hold the small diameter selfi stick, using this as a camera mount is at your own risk. Works best with selfi stick not fully extended. While this mount does a great job, I would not recommend using in rough conditions or erratic riding styles. If a stronger mount is required please check out our other options such as the evolution mount. Loss of camera, mount or damage to ski or persons is your sole responsibility. 

MANY HOURS OF WATER TESTING IN VARIOUS CONDITIONS and I have made sure these are as strong as possible for their purpose, HOWEVER, these are 3D printed mounts, they are being put on fast skis, in unpredictable conditions and riding styles, people get thrown off skis, lose their balance boarding and grab the sticks or poles etc, it is for these reasons there can be NO WARRANTY on these mounts.   This is a really good informative video about the care of your mount https://youtu.be/lmLSSq4XD7Y?si=GcPSLW4tGSI3gHUX

****IMPORTANT*** 

although these are printed with UV and heat resistant materials, it is NOT recommended to leave these in direct heat even under a cover while exposed to direct sunlight when not in use. Some areas like here in Florida etc the temps even under a ski cover can be extreme and cause warping. So if your ski is not covered by a carport/garage etc. please remove your mount for safe storage! 

This mount comes fully assembled and ready to use. Watch the video HERE to check out this mount!

I HIGHLY RECOMMEND that when boarding your ski, you remove this mount and your flag, board the ski, then reinstall. 

NOT RESPONSIBLE FOR IMPROPER INSTALLATION, MOUNT FAILURE DUE TO FALLING INTO/GRABBING FLAG/PASSENGER OR DRIVER THROWN FROM SKI AND HITTING FLAG OR ANY DAMAGE TO FLAG, MOUNT, SKI, LINQ ATTACH POINTS ETC. 

Using a heavy flag pole or double weighted or flags larger than 2x4 may increase the odds of your mount failing. This mount has been extensively tested using the light weight poles… and 2x4 light weight flags. Click here for the flag pole I use! 

YOU ASSUME ALL RESPONSIBILITY BY USING THIS MOUNT!

(overtightening thumbscrews can lead to inserts failing. ALL THAT IS NEEDED IS SNUG!

Proper care and maintenance should be used, cleaned after salt water use, thumbscrew threads oiled etc. 

ONCE THE ORDER HAS SHIPPED IT CAN NOT BE RETURNED FOR ANY REASON...NO EXCEPTIONS. PLEASE ASK ALL QUESTIONS BEFORE ORDERING AS ALL SALES ARE FINAL

**3D printed parts may have slight imperfections such as visible layer lines, stringing or different color shades etc. these do not in anyway affect the integrity of the parts and each and every part is test fit on our skis to assure fitment before it ships**