POWER air vent for SEADOO SKIS

This Twist in rear air vent will let some of that engine heat out thru the pylon access port. It simply twists in place, it is equipped with frog skin material to stop water from entering your hull thru the vent. The vents will be Black and the lettering will be your choice of colors.  Although you CAN choose black for the lettering which means NO LETTERING and yes the cost is more. Sorry. 

IMPORTANT Please ask all questions before ordering as once this ships it can not be returned for ANY REASON!

NRG assumes no liability for any damage for using this vent! USE AT YOUR OWN RISK! 

We do NOT guarantee any improvement or gains of any kind from using this vent.

These are 3D printed with heat resistant materials and are put in high speed crafts, if a common area which can be subject to persons, stepping, grabbing etc so these carry no warranty for breakage during use. These will perform great under usual riding etc. 

MANY HOURS OF WATER TESTING IN VARIOUS CONDITIONS and I have made sure these are as strong as possible for their purpose, HOWEVER, these are 3D printed mounts, they are being put on fast skis, in unpredictable conditions and riding styles, people get thrown off skis, lose their balance boarding and grab the sticks or poles etc, it is for these reasons there can be NO WARRANTY on these mounts.

****IMPORTANT*** 

although these are printed with UV and heat resistant materials, it is NOT recommended to leave these in direct heat even under a cover while exposed to direct sunlight when not in use. Some areas like here in Florida etc the temps even under a ski cover can be extreme and cause warping. So if your ski is not covered by a carport/garage etc. please remove your mount for safe storage! 

**3D printed parts may have slight imperfections such as visible layer lines, stringing or different color shades etc. these do not in anyway affect the integrity of the parts and each and every part is test fit on our skis to assure fitment before it ships**